REPLACING LAMP BALLAST
(OTHER THAN RLT MODELS)
The lamp ballasts are located in the electrical
raceway, in the left-hand end of the merchandiser.
To gain access:
1. Disconnect the electrical power to the light
fixture.
2. Remove the front panel.
A. Pull off the bumper.
B. Remove screws from bumper retainer.
NOTE: The front panel is attached by
(2) screws (two-door),
(3) screws (three -door),
(4) screws (four-door),
(5) screws (five door), to the front panel
C. Lift the front panel up and out from the
front of the case. Tabs on front panel must
clear slots on bumper retainer.
3. Service or replace ballasts as required.
4. Reinstall front panel by sliding it into bumper
retainer slots, then reinstall screws.
5. Install bumper.
6. Restore power to merchandiser.
Reach-In
P/N 0387183_D 6-7
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Bumper
Lift-up on
Front
Panel
Screws
Raceway
Area
Ballas
Bumper
Retainer
Ballasts