STORAGE
When storing the unit at the end of the operating season, the following steps should be taken to ensure readiness for the next season.
1.Remove all grass, dirt, and trash from tractor and mower. Clean tractor and mower and touch up all scrapes with Hustler spray paint.
IMPORTANT: Wash the machine with a mild detergent and water. Do not pressure wash the machine. Avoid excessive use of water
2.Install new air filter per Engine Owner’s Manual.
3.Check thoroughly for any worn or damaged parts that need replacing and order them from your dealer.
4.If the tractor does not have a deck mounted, raise the lift arms hydraulically to their fully raised position so that the lift cylinder is fully retracted. This will protect the cylinder rod surfaces from corrosion.
5.Lubricate the unit. Drain and refill the transmission, hydraulic system and front axle with new oil.
6.Block tractor up so weight is off tires.
7.Do not deflate tires.
8.Perform separate engine preparation as listed below.
9.Store tractor in a clean, dry place.
10.Remove the battery from machine
a.Clean battery
b.Check the electrolyte level
c.Charge the battery, if necessary
d.Store battery in a cool, dry place (do not expose to freezing temperatures)
e.Always keep the battery fully charged. (Especially important to prevent battery damage when the temperature is below 32oF (0oC).)
Preparation of engine for storage
When engine is to be unused for long periods, proceed as follows:
1.Run engine for a minimum of 15 minutes.
2.Drain oil from crankcase while engine is still warm.
3.Refill with fresh oil of proper viscosity.
4.Special precautions should be taken to protect the fuel injection pump and injector nozzle against corrosion and gumming.
5.Flush the fuel system with a special oil, a quantity of which will remain in the system when the engine is shutdown. Special diesel fuel system flushing oils are available from most oil companies. If this oil is not
available, mix 0.5 qts.(0.5 liters) of SAE 10 non- detergent engine oil with 2.64 gal. (10 liters) of No. 2 diesel fuel. Drain the fuel tank and pour 1.85 gal. (7 liters) of the special flushing oil (or lubricating mixture) into the fuel tank. Run the engine for 10 minutes to ensure complete distribution of the special oil through the injection pump and fuel injectors. There is no need to remove the injector nozzles.
6.Fill the fuel tank with No. 1 diesel fuel. IMPORTANT: Do not use No. 2 diesel fuel, for winter storage, because of wax separation and setting at low temperature.
7.Open the drain valve on the radiator. Flush the system, close the drain valve and fill with a 50/50 solution of permanent antifreeze and clear water..
8.Clean exterior surface of engine. Spread a light film of oil over any exposed metal surfaces of engine that are subject to corrosion.
9.Clean dirt and chaff from radiator fins and muffler.
10.Check oil filler cap and fuel tank cap to make certain they are securely in place.
11.Refer to engine manual for more information.
New season preparation
Before starting the tractor following post season storage, the following servicing is required:
1.Clean tractor, removing trash and dirt accumulation.
2.Check engine oil level and common sump (for the hydraulic lift, transmission, front axle and power steering) and the rear axle.
3.Install a fully charged battery.
4.Check the cooling system for proper level of 50/50 solution of
5.Tighten any bolts that have loosened and make sure all hair pins, cotter pins and clevis pins are in place.
6.Install all safety shields and review safety precautions listed in this manual.
7.Check and inflate tires to
8.Refer to engine manual for more information.
9.Start the engine and allow it to idle a few minutes. Be sure the engine has proper oil pressure and that each control is functioning properly.
10.Drive the unit without load and check to be sure it is operating satisfactorily.
PRODUCT LITERATURE
If you would like to view or print a copy of the Hustler 3500/3700 product manuals go online to www.hustlerturf.com and click on the MANUALS button.
109627_0910 |
