10-17
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter10 Configuring MSTP
Configuring MSTP Features
Configuring the Path Cost
The MSTP path cost default value is derived from the media speed of an interface. If a loop occurs, the
MSTP uses cost when selecting an interface to put in the forwarding state. You can assign lower cost
values to interfaces that you want selected first and higher cost values that you want selected last. If all
interfaces have the same cost value, the MSTP puts the interface with the lowest interface number in the
forwarding state and blocks the other interfaces.
Beginning in privileged EXEC mode, follow these steps to configure the MSTP cost of an inter face. This
procedure is optional.
Note The show spanning-tree mst interface interface-id privileged EXEC command displays information
only for ports that are in a link-up operative state. Otherwise, you can use the show running-config
privileged EXEC command to confirm the configuration.
To return the interface to its default setting, use the no spanning-tree mst instance-id cost interface
configuration command.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify an interface to configure, and enter interface
configuration mode. Valid interfaces include physical ports and
port channels. Valid port-channel numbers are 1 to 6.
Step3 spanning-tree mst instance-id cost cost Configure the cost for an MST instance.
If a loop occurs, the MSTP uses the path cost when selecting an
interface to place into the forwarding state. A lower path cost
represents higher-speed transmission.
For instance-id, you can specify a single instance, a range of
instances separated by a hyphen, or a series of instances
separated by a comma. The range is 0 to .
For cost, the range is 1 to 200000000; the default value is
derived from the media speed of the interface.
Step4 end Return to privileged EXEC mode.
Step5 show spanning-tree mst interface interface-id
or
show spanning-tree mst instance-id
Verify your entries.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.