18-10
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBMBladeCenter, Software Configuration Guide
24R9746
Chapter18 Configuring SPAN and RSPAN
Configuring SPAN
This example shows how to configure the destination port for ingress traffic on VLAN 5 by u sing a
security device that does not support IEEE 802.1Q encapsulati on.
Switch(config)# monitor session 1 destination interface gigabitethernet0/17 ingress vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by u sing a
security device that supports IEEE 802.1Q encapsulation.
Switch(config)# monitor session 1 destination interface gigabitethernet0/17 encapsulation
dot1q ingress vlan 5
This example shows how to disable ingress traffic forwarding on the destination port .
Switch(config)# monitor session 1 destination interface gigabitethernet0/17 encapsulation
dot1q
Step3 monitor session session_number source
interface interface-id [, | -] [both | rx | tx]
Specify the SPAN session and the source port (monitored port).
For session_number, specify 1.
For interface-id, specify the source port to monitor. Valid interfaces
include physical interfaces and port-channel logical interfaces
(port-channel port-channel-number).
(Optional) [, | -] Specify a series or range of interfaces. Enter a space
before and after the comma; enter a space before and after the
hyphen.
(Optional) Specify the direction of traffic to monitor. If you do not
specify a traffic direction, the source interface sends both sent and
received traffic.
•both—Monitor both received and sent traffic.
•rx—Monitor received traffic.
•tx—Monitor sent traffic.
Step4 monitor session session_number
destination interface interface-id
[encapsulation {dot1q}] [ingress vlan
vlan id]
Specify the SPAN session, the destination port (monitoring port), the
packet encapsulation, and the ingress VLAN.
For session_number, specify 1.
For interface-id, specify the destination port. Valid interfaces include
physical interfaces.
(Optional) Specify the encapsulation header for outgoing packets. If
not specified, packets are sent in native form.
•dot1q—Use IEEE 802.1Q encapsulation.
(Optional) Enter ingress vlan vlan id to enable ingress forwarding
and specify a default VLAN.
Step5 end Return to privileged EXEC mode.
Step6 show monitor [session session_number] Verify your entries.
Step7 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose