25-4
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBMBladeCenter, Software Configuration Guide
24R9746
Chapter25 Troubleshooting
Using Recovery Procedures
Password Recovery with Password Recovery Enabled
If the password-recovery mechanism is enabled, this message appears:
The system has been interrupted prior to initializing the flash file system. The following
commands will initialize the flash file system, and finish loading the operating system
software:
flash_init
load_helper
boot
Follow these steps when the password-recovery is enabled:
Step1 Initialize the flash file system:
switch: flash_init
Step2 If you had set the serviceport speed to anything other than 9600, it has been reset to that particular speed.
Change the emulation software line speed to match that of the switch serviceport.
Step3 Load any helper files:
switch: load_helper
Step4 Display the contents of flash memory:
switch: dir flash:
The switch file system appears in the directory.
Step5 Rename the configuration file to config.text.old.
This file contains the password definition.
switch: rename flash:
config.text
flash:
config.text.old
Step6 Boot the system:
switch: boot
The switch is set to run on its manufacturing default configuration.
Step7 At the switch prompt, enter privileged EXEC mode:
Switch> enable
Step8 Rename the configuration file to its original name:
Switch# rename flash:
config.text.old
flash:
config.text
Step9 Copy the configuration file into memory:
Switch# copy flash:
config.text
system:
running-config
Source filename [config.text]?
Destination filename [running-config]?
Press Return in response to the confirmation prompts.
The configuration file is now reloaded, and you can change the password.