Auto Setup for the PC
FRANÇAIS ENGLISH
Before carrying out this section, it is very
important that The Setup Diskette for Windows 95 or Windows 98 has been run. (see page 6)
Locate the operating system installed on your PC in the table below and follow the appropriate instructions. You may choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You may run versions of AUTO SETUP in any order.
Operating System | Corresponding Auto Setup procedure |
DOS | Auto Setup for DOS on page 8 |
|
|
Windows 3.1 |
|
|
|
Windows 95 | Auto Setup for Windows 3.1, Windows 95, |
| |
Windows 98 | Windows 98 or Windows NT on page 9 |
| |
|
|
Window NT |
|
|
|
Operating System/2 (OS/2) | Auto Setup OS/2 on page 11 |
ESPAÑOL
If your PC does not run | Before you begin AUTO SETUP for your PC: |
with the setup diskettes | 1. Make a backup copy of the setup diskettes supplied with the monitor. |
shipped with the monitor, refer | |
to Manual Setup on page 13 |
|
2.Make sure the PC’s video mode is set in the range of the supported screen resolution shown in the table on page 20.
The AUTO SETUP process | You should perform AUTO SETUP for each screen mode you use. |
only applies to the current |
|
screen mode. When a new |
|
mode is selected, repeat this |
|
section to reset the monitor |
|
COMPL & WARR JAPANESE ITALIANO
7
