Multifunctional settings

OPTION Menu

With the OPTION menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.

 MENU [RGB]   :SELECT

 PICTURE  ONETOUCH

 IMAGE  AUTO SEARCH  TURN OFF  VIDEO Qlty.  AUTO OFF      0

 INPUT  LAMP TIME     0

 SETUP  FILTER TIME   0

 SCREEN  SERVICE

 OPTION  

 NETWORK

 EASY MENU

Item

Description

 

 

 

Using the buttons ▲/▼ turns on/off the automatic keystone

 

correction function.

 

TURN ON TURN OFF

You can automatically correct vertical keystone distortion corresponding to the angle (forward/backward tilt) at which the unit is set up. This function works with ONE TOUCH operation.

ONE TOUCH • If the projection screen is inclined, or if the projector is angled downwards, it may not be possible to make the correct adjustment when V: INVERT or H&V: INVERT is selected under the MIRROR item of the SETUP menu.

•When the zoom adjustment is set to the TELE side, automatic correction may be excessive. The automatic correction function should be used with zoom set to WIDE whenever possible.

Using the buttons ▲/▼ turns on/off the automatic signal search function.

TURN ON TURN OFF

This function works with INPUT, RGB, and VIDEO buttons.

AUTO SEARCH When the TURN ON is selected, detecting no signal automatically cycles through input ports in order of following. The search is

started from the current port. Then when an input is found, the projector will stop searching and display the image.

RGB IN1 RGB IN2 DVI-D COMPONENT VIDEO S-VIDEO VIDEO

Using the buttons ▲/▼ adjusts the time to count down to automatically turn the projector off.

Long (max. 99 minutes) Short (min. 0 minute = DISABLE)

 

AUTO OFF

AUTO OFF

 

ENABLE

DISABLE

AUTO OFF

1

0

 

 

When the time is set to 0, the projector is not turned off automatically. When the time is set to 1 to 99, and when the passed time with

a no-signal or an unsuitable signal reaches at the set time, the projector lamp will go off and the power indicator begins blinking.

Please refer to the section “Turning off the power” (16).

38