Part names
Part names
Projector
Zoom knob (18)
Focus ring (18)
Vent (6)
Lens (16)
Lamp cover (45) (Lamp unit is inside.)
Remote sensor (15)
Speaker
Elevator button (8)
Front-Right side Elevator foot (8)
Filter cover (46)
(Air filter and intake vent are inside.)
Bottom side
Control buttons (5) | | Speaker |
(See the following page.) | | |
Ports (See below.) | | Elevator button (8) |
AC inlet (13) | | Elevator foot (8) |
| |
Power switch (16) | | Vent (6) |
| Rear-Left side |
| |
DC OUT port | LAN port (12) |
| | | |
USB port (11) | | | | RGB IN1 |
COMPONENT | USB | DC OUT | | |
| LAN | | |
VIDEO ports (12) | | | | |
Y | | COMPONENT VIDEO | RGB OUT |
| |
CB/PB | | | | |
CR/PR | | CR/PR | CB/PB | Y |
| | R-AUDIO IN-L | VIDEO | S-VIDEO |
AUDIO IN L/R port (12)
S-VIDEO port (12)
Restart switch (*) (52)
| | RGB IN1 port (11) |
RGB IN2 | | DVI-D port (11) |
| DVI-D | RGB IN2 port (11) |
| AUDIO-IN AUDIO-OUT | |
| REMOTE | AUDIO OUT port (11) |
CONTROL | CONTROL | |
AUDIO IN port (11)
WIRED REMOTE port
CONTROL port (11)
RGB OUT port (11)
NOTE (*) About Restart switch: This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.