Related service information
without knowing the password, nobody can change the configuration of the computer.
Attention
If the SVP has been forgotten, there is no way to reset it.
How to remove the power-on password
To remove a POP that you have forgotten, do the following:
(A) If SVP is not installed:
1.Turn off the computer.
2.Remove the battery pack.
For how to remove the battery pack, see “1010 Battery pack” on page 51.
3.Remove the backup battery.
For how to remove the backup battery, see “1040 Backup battery” on page 55.
4.Turn on the computer and wait until the POST ends.
After the POST ends, the password prompt does not appear. The POP has been removed.
5.Reinstall the backup battery and the battery pack.
(B) If SVP is installed:
1.Turn on the computer by pressing and holding F1.
2.Enter the SVP. The IBM BIOS Setup Utility menu appears.
3.Select Password, using the cursor keys to move down the menu.
4.Select Power-On Password.
5.Enter the SVP, at the Enter Current Password field.
6.When the Enter New Password field opens, leave it blank and press Enter twice.
7.Press Enter in the Changes have been saved window.
8.Press F10; then select Yes in the Setup confirmation window.
How to remove the hard-disk password
Attention
If User only mode is selected and the user HDP is forgotten, there is no way to reset it.
General descriptions 23
