Symptom-to-FRU index

3.If any error is detected, replace the FRU shown by the FRU code. Rerun the test to verify that no more errors exist.

Undetermined problems

You are here because the diagnostic tests did not identify which adapter or device failed, wrong devices are installed, a short circuit is suspected, or the system is inoperative. Follow these procedures to isolate the failing FRU (do not isolate FRUs that have no defects).

Verify that all attached devices are supported by the computer.

Verify that the power supply being used at the time of the failure is operating correctly. (See “Power system checkout” on page 29.)

1.Power off the computer.

2.Visually check each FRU for damage. Replace any damaged FRU.

3.Remove or disconnect all of the following devices:

a.Non-IBM devices

b.Devices attached to the port replicator

c.Printer, mouse, and other external devices

d.Battery pack

e.Hard-disk drive

f.External diskette drive

g.DIMM

h.CD-ROM and diskette drive in the UltraslimBay

i.PC Cards

4.Power on the computer.

5.Determine whether the problem has changed.

6.If the problem does not recur, reconnect the removed devices one at a time until you find the failing FRU.

7.If the problem remains, replace the following FRUs one at a time (do not replace a nondefective FRU):

a.System board

b.LCD assembly

FRU replacement notices

This section contains notices related to removing and replacing parts. Read this section carefully before replacing any FRU.

Screw notices

Loose screws can cause a reliability problem. The an IBM ThinkPad computer address this problem with special nylon-coated screws that have the following characteristics:

vThey maintain tight connections.

vThey do not easily come loose, even with shock or vibration.

ThinkPad A21e 47

Page 51
Image 51
IBM MT 2632 manual Undetermined problems, FRU replacement notices, Screw notices