However, if the storage agent inaccurately identifies a LAN-free destination and
the server is unable to process the request, the operation has advanced past the
point where LAN failover will occur and the storage agent request will be
unsuccessful. If this occurs, halt and restart the storage agent and then retry the
operation.
Adding Communication Information for the Storage Agent
The DSMSTA SETSTORAGESERVER utility initializes the storage agent and adds
communication information to the device configuration file and the dsmsta.opt file.
Use this utility on the client system where the storage agent has been installed. See
“Install and Configure the Storage Agent” on page 21 for more information on
when to use this command.
This utility does not remove any previous entries in the files. It appends
information to the existing files. The option DEVCONFIG, which sets a name for
the device configuration file, must be in the dsmsta.opt file for the command to
work. See “Examples” on page 45 for details on the information that the command
adds.
Format
 DSMSTA SETSTORAGESERVER MYName = storage_agent_name
MYPAssword = storage_agent_password
MYHLAddress = storage_agent_hladdress SERVERName = server_name
SERVERPAssword = server_password HLAddress = server_tcpip_address
LLAddress = server_tcpip_port 
Parameters
All parameters are required.

Note: Allowed abbreviations for the options are shown in uppercase letters.

MYName
Specifies the name of the storage agent. This name appears in the SET
STANAME command that is inserted into the device configuration file.

Note: Yo u must use the same name when you define the storage agent as a

server to the Tivoli Storage Manager server.

MYPAssword
Specifies the password of the storage agent. This value is encrypted and used
in the SET STAPASSWORD command that is inserted into the device

configuration file.

Note: Yo u must use the same password when you define the storage agent as

a server to the Tivoli Storage Manager server.

MYHLAddress
Specifies the TCP/IP address of the storage agent. This value is used internally
in the SET STAHLAddress command that is inserted into the device
configuration file.
44 IBM Tivoli Storage Manager for SAN for AIX: Storage Agent User’s Guide