T50_setup.fm Page 7 Thursday, August 9, 2001 11:09 AM
ENGLISH
Setup Diskette for Windows 2000
This section must be completed before continuing with the Windows 2000 confguring for your monitor.
On LCD monitors, unlike CRTs, a faster refresh rate
does not improve display quality. IBM recommends using either 1024 x 768 at a refresh rate of 60Hz.
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Flat Panel Monitor Installation diskette.
1.Turn off the computer and all attached devices.
2.Ensure that the monitor is connected correctly.
3.Turn on the monitor and then the system unit. Allow the system to boot into Windows 2000.
4.Open the DISPLAY PROPERTIES window by clicking on START, SETTINGS, CONTROL PANEL and then double clicking on the DISPLAY icon.
5.Select the SETTINGS tab.
6.Select the ADVANCED button.
7.Select the MONITOR tab.
8.Select the PROPERTIFS button.
9.Select the Driver tab.
10.Open the Upgrade Device Driver Wizard window by clicking on UPDATE DRIVER and then select the NEXT button.
11.select the “Display a list of the known dirvers for this device so that lcan choose a specifc driver” and then sefect the NEXT button.
12.Inset the Setup diskette into drive A: and select the HAVE DISK button.
13.select OK.
14.Choose IBM T50 monitor and select OK. The files will be copied from the diskette to your hard drive.
15.Close all open windows and remove the diskette.
16.Reboot the system.
The system will automatically select the maximum refresh rate and corresponding Color Matching Profiles.
FRANÇAIS
COMPL & WARR JAPANESE ITALIANO ESPAÑOL
7