IBM 9511-AWC Manual Setup, might automatically turn off while you are waiting for it to warm up

T50_setup.fm Page 12 Thursday, August 9, 2001 11:09 AM

Manual Setup

If the monitor is in standby mode (STANDBY ON), it

might automatically turn off while you are waiting for it to warm up.

Normally, you can complete the setup procedure using AUTO SETUP, however, if your screen image is still distorted after you perform AUTO SETUP or the setup diskette does not run on your system, perform MANUAL SETUP.

1.Have your monitor turned on for about 15 minutes, until the monitor warms up.

2.Display the image you most frequently use on the screen.

3.Press the OSD Menu button at the bottom of the monitor to display the initial OSD menu.

4. Use buttons ( - ,+) to select the IMAGE LOCK icon		and press the
OSD Menu button	to access the function.

5.Using buttons ( - ,+), select MANUAL, press and then press “+ “ once to select COARSE. Left and right adjustment indicators become illuminated.

6.Use the buttons ( - ,+) to manually adjust to correct (as much as possible) for noise in the video signal then press Exit to save the changes.

7.Use buttons ( - ,+) to select FINE and press the button.

8.Use the buttons ( - ,+) again to tune the image to your liking.

9.When finished, press the Exit button four times to exit from the OSD.

You have completed the monitor setup.

12