IBM 9511 Attaching the stand and cables, Français English Español, Compl & Warr Japanese Italiano

T50_setup.fm Page 23 Thursday, August 9, 2001 11:09 AM

2.Place the monitor panel-side down on a stable, padded, flat work surface.

3.Remove the four mounting plate retaining screws. One screw at each corner. Lift the base up and away from the monitor.

FRANÇAIS ENGLISH

ESPAÑOL

Attaching the stand and cables

1.Turn off the monitor and unplug it from the electrical outlet.

2.Place the monitor panel-side down on a stable, padded, flat work surface

3.Align the screw holes on the swivel base with the corresponding holes on the back of the monitor.

4.Insert and loosely secure the four screws on the base. Tighten the screws in an alternating pattern and make sure not to over-tighten.

To obtain the correct cables and/or to get further instructions on installing them, call the IBM HELPCENTER at the above numbers or contact your dealer, retailer, or other IBM authorized Servicer.

COMPL & WARR JAPANESE ITALIANO

23