IBM T 55A manual English

Auto Setup for Windows 3.1, Windows 95, Windows 98 or Windows NT

ENGLISH

If the monitor is in standby mode (STANDBY ON), it

may automatically turn off while you are waiting for it to warm up.

The size and diversity of the dot pattern varies with

the screen resolution.

1.Turn on the monitor first; then the PC.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed check:

•that the video interface cable is connected properly.

•the correct video adapter card is installed.

•the correct supported display mode is selected for your PC.

2.Wait approximately 15 minutes, until the monitor warms up.

3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.

4.Insert the diskette labelled ‘IBM Monitor Installation Disk’ into the diskette drive.

5.Check the operating system installed on your PC and follow the instructions from the table below.

Operating	Step1	Step2	Step3	Step4
System
Windows 3.1	Open	Select	Select
	PROGRAM
Windows NT 3.5		FILE	RUN	Type
	MANGER
				‘A:\TESTPAT’
Windows 95
	Select			and press
		Select RUN		ENTER
Windows 98
	START
Windows NT 4.0

FRANÇAIS

ITALIANO ESPAÑOL

Position the mouse pointer at the bottom center of the

screen. This allows AUTO SETUP to run properly

6.When the test pattern appears, press the OSD Enter button at the bottom of the monitor to display the initial OSD menu.

7.Use an Arrow button ( or ) to select the IMAGE LOCK icon

and press the OSD Enter button to access the function.

8.Using an Arrow button ( or ), select AUTOMATIC and press the OSD Enter button . This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern.

The screen will dim, blink on and off several times, and you may notice small changes to the test pattern.

To abort the AUTO SETUP function, press the ESC key.

9.When finished, the OSD main menu returns. Press the Exit button once to exit from the OSD.

COMPL & WARR JAPANESE

9