IBM VT575, VT470, VT676, VT670 manual

1. Introduction

Terminal Panel Features		4	1
VT676/VT670/VT575/VT470	VIDEO IN	L/MONO AUDIO R	COMPUTER 1 IN AUDIO COMPUTER 2 IN
	S-VIDEO IN	L/MONO AUDIO R AUDIO OUT	PC CONTROL
			MONITOR OUT

		3	2	5
	4		1
VT47	VIDEO IN L/MONO	AUDIO R	AUDIO COMPUTER IN
	S-VIDEO IN		MONITOR OUT	PC CONTROL
	3		2	5

1.COMPUTER 1 and 2 IN / Component Input Connector (Mini D-Sub 15 Pin) (One COMPUTER port on VT47)

Connect your computer or other analog RGB equip- ment such as IBM compatible or Macintosh comput- ers. Use the supplied RGB cable to connect to your computer. This also serves as a component input con- nector that allows you to connect a component video output of component equipment such as a DVD player. This connector also supports SCART output signal. See page 16 for more details.

COMPUTER AUDIO Input Mini Jack (Stereo Mini)

This is where you connect the audio output from your computer or DVD player when connected to the COM- PUTER input. A commercially available audio cable is required.

2.MONITOR OUT Connector (Mini D-Sub 15 Pin)

You can use this connector to loop your computer image to an external monitor from the RGB input source.

This connector outputs RGB signal in standby mode.

AUDIO OUT Mini Jack (Stereo Mini) (Not available on VT47)

For example, when a cable mini-plug is inserted into the left AUDIO IN jack only, only left sound is output.

3.S-VIDEO IN Connector (Mini DIN 4 Pin)

Here is where you connect the S-Video input from an external source like a VCR.

NOTE: S-Video provides more vivid color and higher resolution than the traditional composite video format.

S-VIDEO AUDIO Input Jacks L/R (RCA)

These are your left and right channel audio inputs for stereo sound from an S-Video source.

4.VIDEO IN Connector (RCA)

Connect a VCR, DVD player, laser disc player, or docu- ment camera here to project video.

VIDEO AUDIO Input Jacks L/R (RCA)

These are your left and right channel audio inputs for stereo sound from a Video source.

NOTE: The VIDEO AUDIO inputs can also be used as S- VIDEO AUDIO inputs on VT47.

5.PC CONTROL Port (DIN 8 Pin)

You can use this jack to output sound from the cur- rently selected source (COMPUTER, VIDEO or S- VIDEO). Output sound level can be adjusted in accor- dance with the sound level of the internal speaker.

Note that this cannot be used as a headphone jack.

(When audio equipment is connected, the projector speaker is disabled.)

When a cable mini-plug is inserted into this jack, both the right and left audio signals are not mixed, but sepa- rate.

Use this port to connect a PC or control system. This enables you to control the projector using serial com- munication protocol. If you are writing your own pro- gram, typical PC control codes are on page 62.

7