IBM 2. Installation and Connections, 4.Turn on the projector and DVD player, Connect the supplied power cable. See page

2. Installation and Connections

Connecting Your DVD Player with Component Output

VT676/VT670/VT575/VT470VT47

COMPUTER 1 IN			AUDIO	COMPUTER IN
VIDEO IN	L/MONO AUDIO R	COMPUTER 1 IN	AUDIO COMPUTER 2 IN	VIDEO IN	L/MONO AUDIO R AUDIO	COMPUTER IN
S-VIDEO IN	L/MONO AUDIO R	AUDIO OUT	PC	S-VIDEO IN		PC CONTROL
		OUT

AC IN

Optional 15-pin - to - RCA (female) ￿3 cable (ADP-CV1)

Component video RCA￿3 cable (not supplied)

Audio Equipment

DVD player

Y Cb Cr L R

Component	AUDIO IN
	L R

Audio cable (not supplied)

You can connect your projector to a DVD player with component output or Video output. To do so, simply:

1.Turn off the power to your projector and DVD player.

2.If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable (RCA￿3) and the optional 15-pin-to-RCA (female)￿3 cable to connect your DVD player to the COMPUTER IN connector on the projector.

For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a composite VIDEO output of the DVD player to the Video Input of the projector.

3.Connect the supplied power cable. See page 20.

4.Turn on the projector and DVD player.

A component signal will be automatically displayed. If not, from the menu, select [Advanced] → [Signal Select] → [Computer], and then place a check mark in the Component radio button.

NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.

18