| IOD16022 |
Installation: General | IOD22030 |
Ice Machine Installation
Make sure the counter the dispenser is place on is structurally able to hold the combined weight of the dispenser, ice and ice machine.
Remove the dispenser cover. (Retain for future use)
Place the appropriate stainless steel KBT adapter onto the top of the dispenser.
22 inch wide ice machine on a | Part number KBT2222 |
22 inch wide ice machine on a | Part Number KBT2230 |
30 inch wide ice machine on a | Part Number KBT3030 |
Install the thermostatic bin control kit when applicable. Part Number
Note: The thermostatic bin control kit is required on all ICE Series Cubers.
Using silicone sealant, place a bead of sealant onto the top edges of the area on the adapter where the ice machine will go.
Install the ice machine onto the dispenser, center the machine left to right and align the machine flush to the back.
Install the thermostatic bin control cap tube into the thermal well mounted in the bin.
Note: The thermostatic bin control kit is required on all ICE Series Cubers.
Fasten together at the back of the machine using fasteners from the icemaker and mounting hardware from the kit.
Place the front cover plate onto the dispenser in front of the ice machine.
Follow the ice machine
Completion
Make a final check for any leaks and correct as necessary.
Reinstall the splash panel and secure it with two Phillips head screws.
Check for proper operation of the dispense system.
Instruct the site manager regarding the requirements for maintaining, operation and sanitizing the dispenser.
Page 7