| IOD16022 |
Installation: General | IOD22030 |
Equipment Description
The IOD16022 and IOD22030 are counter top mounted ice only dispensers. These units are designed to dispense cube ice only and have ice storage capacities of 160 lb. and 220 lb. respectively.
Site Preparation
The site chosen for the dispenser must be capable of supporting the dispenser with a full bin of ice plus all other loads being placed on the surface supporting the dispenser. If an ice machine is being placed on the dispenser, the weight of the ice machine must be included in the calculations to determine the support structure needed for the dispenser.
Allow sufficient clearance above the unit for removal of the cover and for pouring ice into the bin.
A 115 volt, 15 amp electric outlet needs to be located within 6 feet of the unit. The outlet must be properly grounded and fused. No other electrical appliance should be on the circuit. ALL ELECTRICAL WIRING MUST CONFORM TO NATIONAL AND LOCAL CODES
Do not place the dispenser next to heat sources such as ovens, heat ducts or in the warm air discharge from adjacent equipment.
The unit must be located near a building drain. Drain lines must be properly vented and pitched to ensure free flowing of wastewater to the drain.
These dispensers are designed to dispense cubed ice only. Do not use flaked, crushed or compressed ice forms.
If an
Ice Machine Adapter | 22 inch cuber | Part Number KBT2222 |
Ice Machine Adapter | 22 inch cuber on 30 wide dispenser | Part Number KBT2230 |
Ice Machine Adapter | 30 inch cuber | Part Number KBT3030 |
Dispenser Preparation
Remove the shipping carton and discard.
Remove the merchandiser by lifting up on the merchandiser and pulling it forward.
Remove the drain pan from the skid, and all hardware from the bin.
Remove the splash panel by removing the two phillips head screws near the bottom corners of the panel.
Remove the 4 brackets holding the dispenser to the skid.
(Optional) Screw 4 legs into the well nuts in the bottom of the dispenser.
In order to comply with NSF requirments, this unit must be either elevated above the counter top sufficiently to provide space for cleaning under the unit or the unit must be sealed to the counter top. Elevating the unit may be accomplished by using legs. (IOM Part Number KIOD4)
Page 4
