Icom IC-F3062T, IC-F3061T, IC-F3062S, IC-F3061S, IC-F3063S, IC-F3063T service manual Introduction

INTRODUCTION

This service manual describes the latest service information for the IC-F3061T/S,IC-F3062T/S and IC-F3063T/SVHF TRANSCEIVER at the time of publication.

MODEL	VERSION	SYMBOL	CHANNEL SPACING	KEY PAD
IC-F3061T	U.S.A	[USA-01]	15.0 kHz/30.0 kHz	10-key
IC-F3061S				4-key
IC-F3062T	EURO	[EUR-01]	12.5 kHz/25.0 kHz	10-key
IC-F3062S				4-key
IC-F3063T	GENERAL	[GEN-01]	12.5 kHz/20.0 kHz	10-key
IC-F3063S			/25.0 kHz	4-key

To upgrade quality, all electrical or mechanical parts and internal circuits are subject to change without notice or obligation.

DANGER

NEVER connect the transceiver to an AC outlet or to a DC power supply that uses more than 7.2 V. Such a connection could cause a fire or electric hazard.

DO NOT expose the transceiver to rain, snow or any liquids.

DO NOT reverse the polarities of the power supply when connecting the transceiver.

DO NOT apply an RF signal of more than 20 dBm (100 mW) to the antenna connector. This could damage the trans- ceiver's front end.

ORDERING PARTS

Be sure to include the following four points when ordering replacement parts:

1.10-digit Icom parts number

2.Component name and informations

3.Equipment model name and unit name

4.Quantity required

<SAMPLE ORDER>

5030002830	LCD	M4-0078TAY-2	IC-F3061T	Front unit	5 pieces
8810009220	Screw	PH B0 M2⋅8 ZK (BT) IC-F3061T		Chassis	10 pieces

Addresses are provided on the inside back cover for your convenience.

REPAIR NOTES

1.Make sure the problem is internal before disassembling the transceiver.

2.DO NOT open the transceiver until the transceiver is disconnected from its power source.

3.DO NOT force any of the variable components. Turn them slowly and smoothly.

4.DO NOT short any circuits or electronic parts. An insulated turning tool MUST be used for all adjustments.

5.DO NOT keep power ON for a long time when the transceiver is defective.

6.DO NOT transmit power into a signal generator or a sweep generator.

7.ALWAYS connect a 30 dB to 40 dB attenuator between the transceiver and a deviation meter or spectrum analyzer when using such test equipment.

8.READ the instructions of test equipment thoroughly before connecting equipment to the transceiver.

Icom, Icom Inc. and logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries.