Icom IC-F5061 Introduction, Ordering Parts, Repair Notes, Model Version Channel Spacing TX Power

INTRODUCTION CAUTION

This service manual describes the latest service information for the IC-F5061/F5062/F5063VHF TRANSCEIVERS at the time of publication.

MODEL	VERSION	CHANNEL SPACING	TX POWER
IC-F5061	USA-01	15.0/30.0 kHz	50 W
IC-F5062	EXP-01	12.5/25.0 kHz	25 W
IC-F5063	EUR-01	12.5/20/25.0 kHz

To upgrade quality, any electrical or mechanical parts and internal circuits are subject to change without notice or obligation.

NEVER connect the transceiver to an AC outlet or to a DC power supply that uses more than 15 V. This will ruin the transceiver.

DO NOT expose the transceiver to rain, snow or any liquids.

DO NOT reverse the polarities of the power supply when connecting the transceiver.

DO NOT apply an RF signal of more than 20 dBm (100 mW) to the antenna connector. This could damage the transceiver’ s front end.

ORDERING PARTS

Be sure to include the following four points when ordering replacement parts:

1.10-digit Icom parts numbers

2.Component part number and name

3.Equipment model name and unit name

4.Quantity required

<SAMPLE ORDER>

1110003491	S.IC	TA31136FNG	IC-F5061	MAIN UNIT	5 pieces
8820001210	Screw	2438 screw	IC-F5062	Top cover	10 pieces

Addresses are provided on the inside back cover for your convenience.

REPAIR NOTES

1.Make sure a problem is internal before disassembling the transceiver.

2.DO NOT open the transceiver until the transceiver is disconnected from its power source.

3.DO NOT force any of the variable components. Turn them slowly and smoothly.

4.DO NOT short any circuits or electronic parts. An insulated tuning tool MUST be used for all adjustments.

5.DO NOT keep power ON for a long time when the transceiver is defective.

6.DO NOT transmit power into a signal generator or a sweep generator.

7.ALWAYS connect a 50 dB to 60 dB attenuator between the transceiver and a deviation meter or spectrum analyzer when using such test equipment.

8.READ the instructions of test equipment thoroughly before connecting equipment to the transceiver.

Icom, Icom Inc. and logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries.