Icom IC-F5062 Receive Adjustment, Convenient, Adjustment Adjustment Condition Unit Location Value

6-4 RECEIVE ADJUSTMENT

Select an adjustment item using [↑] / [↓] keys, then set to the specified value using [←] / [→] keys on the connected PC’s keyboard.

ADJUSTMENT

ADJUSTMENT CONDITION

UNIT

LOCATION

VALUE

RECEIVE	NOTE: “RECEIVE SENSITIVITY” must be adjusted before “S-METER.” Otherwise, “S-METER” will not be
SENSITIVITY		adjusted properly.
[BPF (T1) C]
	1	• Channel	: CH 3	SP jack	Connect the SINAD meter	Minimum distortion
[BPF (T2) C]
		• Connect the SSG to the antenna connec-			with an 4 Ω load to the SP	level
		tor and set as;			jack.
		Frequency	: 136.000 MHz
		Level	: +20 dBµ† (–87 dBm)
		Modulation	: 1 kHz
		Deviation	: ±3.5 kHz
		• Receiving
	CONVENIENT:

The “RECEIVE SENSITIVITY” can be adjusted automatically.

1:Put the cursor on “[BPF C ALL]” and push [ENTER] key.

2:The connected PC tunes BPF’s to peak levels automaticaly.

S-METER	1	• Channel	: CH 3	Push the [ENTER] key on the connected PC’s keyboard to set
(S3 level)		• Connect the SSG to the antenna connec-		“S3” level.
[RSSI]		tor and set as;
		Frequency	: 136.000 MHz
		Level	: +23 dBµ† (–84 dBm)
		Modulation	: 1 kHz
		Deviation	: ±3.5 kHz
		• Receiving
(S1 level)	2	• Set the SSG as;	: –7 dBµ† (–114 dBm)	Push the [ENTER] key again to set “S1” level.
		Level
		• Receiving
SQUELCH	1	• Channel	: CH 3	External	Connect an 4 Ω speaker to	Close the squelch by
[SQL]		• Close the squelch by adjusting the value of		speaker	the SP jack.	increase the value of
		[SQL] item on the CS-F5060 ADJ’s screen.				[SQL].
		• Connect the SSG to the antenna connec-				Set the [SQL] to the
		tor and set as;				value that the audio
		Frequency	: 136.000 MHz			signals just appear.
		Level	: –14 dBµ† (–121 dBm)
		Modulation	: 1 kHz
		Deviation	: ±3.5 kHz
		• Receiving

†; The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.

6 - 6