Ikelite 6871.07 instruction

Attaching an Ikelite Strobe Arm to the Housing Handle

To attach an Ikelite Arm to your Housing Handle, depress the spring-loaded Handle Push Button until it stops. Gently slide the pronged end of the Ikelite Arm into the hole in the top of the Handle as shown.

When the Ikelite Arm is properly seated, the Handle Push Button will return to its starting position.

Ikelite Arm

Housing Handle

Handle Push

Button

21

Image 21

Ikelite 6871.07 instruction manual Attaching an Ikelite Strobe Arm to the Housing Handle

Contents

Canon EOS 7D SLR-DC Housing Table of Contents Specifications Preparation Package Contents Side View Parts of the Housing Front View Back View Opening the Housing Initial Camera Setup Setting the Conversion Circuitry Strobe ID Switch Housing Conversion Circuitry Mode and Compensation Buttons Using the Conversion Circuitry Set DS Substrobe to TTL mode Attaching the Flash Connection for External Strobes DS50 and DS125 Substrobe Compatibility Installing Camera in Housing Attaching Camera to Housing Tray Final Check Closing the Housing Turn Camera On Attaching a Sync Cord to the Housing Zoom Clamps & Gear Sleeves Included with Housing Preparing to Install Zoom Clamp & Gear Sleeve Installing the Zoom Clamp & Gear Sleeve On the Type 1 Lenses Figure D Type 1 Lenses Installing the Zoom Clamp & Gear Sleeve On Type 2 Lenses Manual Focusing Installing Zoom Clamp/Sleeve on Type 2 Lenses Installing the Port Installing the Port To Remove Port Port Seal Inside ViewLens Ports Attaching an Ikelite Strobe Arm to the Housing Handle Usage Pre-Dive Your SystemLubricants Problem Solution Troubleshooting Any trapped moisture forming fog on the lens port Recommended Accessories Accessory Mounting PointsEV-Controller Use Control Maintenance Maintenance Diagram B Housing Maintenance Storing the Housing Spare PartsPhoto Tips Photo Tips Technical Support Limited Warranty Returning Products For ServiceReturning Products for Service outside the United States Product Registration