Type 1 Lenses, Figure D | Ikelite 6871.07 instruction

Type 1 Lenses - continued

Gear Sleeve Ribs

Align Ribs with Zoom Clamp grooved tabs

Figure D

apply

rubber strips

to inside of

clamp

Figure E

Figure F

16

Image 16

Ikelite 6871.07 instruction manual Type 1 Lenses, Figure D

Contents

SLR-DC Housing Canon EOS 7D Table of Contents Specifications Package Contents Preparation Parts of the Housing Front View Side View Back View Initial Camera Setup Opening the Housing Housing Conversion Circuitry Setting the Conversion Circuitry Strobe ID Switch Using the Conversion Circuitry Set DS Substrobe to TTL mode Mode and Compensation Buttons DS50 and DS125 Substrobe Compatibility Attaching the Flash Connection for External Strobes Attaching Camera to Housing Tray Installing Camera in Housing Closing the Housing Final Check Attaching a Sync Cord to the Housing Turn Camera On Preparing to Install Zoom Clamp & Gear Sleeve Zoom Clamps & Gear Sleeves Included with Housing Installing the Zoom Clamp & Gear Sleeve On the Type 1 Lenses Type 1 Lenses Figure D Installing the Zoom Clamp & Gear Sleeve On Type 2 Lenses Installing Zoom Clamp/Sleeve on Type 2 Lenses Manual Focusing Installing the Port Port Seal Inside View Installing the Port To Remove PortLens Ports Attaching an Ikelite Strobe Arm to the Housing Handle Pre-Dive Your System UsageLubricants Troubleshooting Problem Solution Any trapped moisture forming fog on the lens port Accessory Mounting Points Recommended AccessoriesEV-Controller Use Maintenance Control Maintenance Diagram B Housing Maintenance Spare Parts Storing the HousingPhoto Tips Technical Support Photo Tips Returning Products For Service Limited WarrantyReturning Products for Service outside the United States Product Registration