Type 2 lens

Installing the Zoom Clamp & Gear Sleeve On Type 2 Lenses

Due to the larger diameter lens opening on Type 2 lenses, the Zoom Clamp and Gear Sleeve need to be installed from the rear (bayonet end) of the lens. Use the housing Lens Release Control and remove the camera lens from the camera body, after the camera and lens have been installed in the housing.

Place the Gear Sleeve in the housing opening as shown.

Install the black Zoom Clamp on the Lens Zoom Ring and lower the lens into the housing opening. Make sure the Zoom Clamp grooved tabs align with the Gear Sleeve ribs. If necessary, install rubber strips to expand the Zoom Clamp so it meshes properly with the Gear Sleeve. Bayonet lens into camera body and align Gear Sleeve teeth with Black Housing Gear Teeth.

Lens Zoom Ring

Zoom Clamp

Gear Sleeve

TOP OF HOUSING

Lens Manual Focus Ring

Align

Zoom Clamp grooved tabs with Gear Sleeve Ribs

17

Page 17
Image 17
Ikelite 6871.07 instruction manual Installing the Zoom Clamp & Gear Sleeve On Type 2 Lenses