STEP 11 (See Diagram 11 & Cable Loop Diagram)
A.) | Attach the 159” Lower Cable (#58) to the opening bracket on Leg Developer (#7). |
B.) | Attach a Pulley (#40) to the opening. Secure it with one M10 x 2 ½” Allen Bolt |
| (#76), two ∅ 1” x 5/8” Pulley Bushings (#52), and one M10 Aircraft Nut (#97). |
C.) | Draw the Cable underneath the Pulley to the opening on Vertical Seat Support |
| (#6). Repeat B to install a Pulley. |
D.) | Draw the Cable underneath the Pulley through the opening on bottom of Vertical |
| Frame (#4), to the open bracket on Base Frame (#3). |
E.) | Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#74), |
| two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#97). |
F.) | Draw the Cable around the Pulley then upward to the Angled Floating Pulley |
| Bracket (#16) installed in |
G.) | Draw the Cable around the Pulley then downward to an open bracket on Base |
| Frame. Repeat E to install a Pulley. |
H.) | Draw the Cable around the Pulley and pull the Cable upward to the Double |
| Floating Pulley Brackets (#16) previously installed in |
I.) | Attach a Pulley to selected holes. Secure the Pulley with one M10 x 2” Allen Bolt |
| (#75), two Ø ¾” Washers (#91), two Cable Retainer (#99), and one M10 Aircraft |
| Nut (#97). |
J.) | Draw the Cable around the Pulley and downward to the open bracket on Base |
| Frame. Secure the end of Cable to the bracket with one M10 x 1’ Allen Bolt |
| (#81), two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#97). |
K.) | If the whole Cable system is too loose, adjust the tension of the cable system by |
| moving up or down the lower pulley on the Double Floating Pulley Bracket. |
| Moving up the pulley up will increase the tension in the pulley system; |
| conversely, lowering the pulley will decrease the tension. |
22
