Page 9INF55WIN8 Hardware Guide
Setup

Installing the Feet

1) If you have not already done so, carefully place your monitor face-down on a clean, cushioned surface with the top edge hang-
ing o of the cushioned surface by 4-5” (10-13cm). Do NOT place the monitor on its back.
2) Remove the monitor feet slot covers with a Philips screwdriver. Discard or save for future use.
3) Slide the feet into the slots provided (the longer side of the feet point toward the front of the monitor), then secure the legs to
the monitor with the provided screws.
4) Using the handles on the back of the monitor, li the monitor upright.
For addional accessory opons, such as stands, carts and wall mounts, see the InFocus website (www.infocus.com/store) or your
local dealer.

WARNINGS:

• This monitor is very heavy and should be moved by at least two individuals.
• Three screw holes have been included in each leg to allow you to adjust the height of the monitor. Regardless of the height, you
must use two of the screw holes in each leg. Failure to do so may result in the screw begin sheared o and the leg collapsing.
• When mounng the monitor to a wall, metric 8 (12mm) screws must be used. In addion, the mounng interface should comply
with the UL1678 standard in North America. The mounng means should be strong enough to bear the weight of the monitor
(approximately 114.2 lbs/51.8 kg without the stand).
Secure the legs here unless a sound bar is
being aached.
(The spacers are not used.)
Front View
Use the included spacers and
secure the legs here, when
aaching a sound bar.