Page 13INF55WIN8 Hardware Guide
Setting up the Wireless Mouse and Keyboard
Note: The wireless mouse and keyboard set is not included as a standard accessory for some countries. For inial setup and/or con-
guraon, it may be easier to use a mouse and keyboard. Any standard wired or wireless mouse or keyboard connected through the
monitor's USB ports can be used.

Wireless Mouse

1) Turn the mouse over and remove the baery cover.
2) Remove the USB dongle from its holder in the baery compartment of the mouse.
3) Plug it into a free USB-A port on the Bezel Connector Panel of the moni-
tor. You may be asked to go online to nd the necessary drivers. If you
are warned that the drivers have not been tested for compability, tap
Connue installaon to nish.
4) Insert two (2) AAA baeries (not included) into the mouse by aligning the
+ and – end of the baeries as indicated and sliding them in place.
5) Replace the cover and switch the mouse ON using the slide switch next to
the baery bay.

Wireless Keyboard

1) Turn the keyboard over and open the baery cover.
2) Insert two (2) AAA baeries (not included) into the keyboard, by aligning
the + and – ends of the baeries and sliding them in place.
3) Replace the cover.
4) Press the CONNECT buon and hold it for one second to allow the key-
board to bind with the dongle.