Replacing the Projection Lamp | InFocus LP290 specification

Replacing the Projection Lamp

The lamp hour timer in the Service Info menu counts the number of hours the lamp has been in use. When the timer reaches 2000 hours, the Alarm LED lights red, indicating that it is time to change the lamp. You can order new lamp housings from your InFocus dealer. See “Accessories” on page 40 for information.

Follow these steps to replace the projection lamp:

1Turn off the projector and unplug the power cord.

2Wait 60 minutes to allow the projector to cool thoroughly.

3Loosen the three captive screws on the lamp housing.

FIGURE 23

Loosening the screws on the lamp housing

4Carefully remove the lamp housing. Dispose of the lamp in an environmentally proper manner.

WARNING: To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp. Never extract the lamp housing while the projec- tor is operating.

WARNING: Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small glass fragments may be generated. The lamp mod- ule is designed to contain these fragments, but use caution when removing the lamp module.

31

Image 37

InFocus LP290 instruction manual Replacing the Projection Lamp

Contents

FCC Warning Canada Safety CertificationsEN 55022 Warning Australian Certification C-tick mark Trademarks Declaration of Conformity Table of Contents Index Appendix Safety Definitions Safety Symbols Safety InstructionsSafety Terms Important Operating Considerations Customer Service Introduction Image ResolutionLP280 LP290 Unpacking the Projector CompatibilityDiately if anything is missing Shipping box contents Rear view of projector If You Need Assistance Usage Guidelines Warranty F t Setting UP the Projector T t i n g O j e c t o r Do you want to play your computer’s audio on the projector? Connecting a Computer T t i n g O j e c t o r Connecting a Video Player T t i n g O j e c t o r Powering up the Projector Turning Off the Projector Basic Image Adjustment Using the ProjectorAdjusting the Projector I n g O j e c t o r Using the Remote Control Power Using the Keypad and Remote ButtonsMenu Source/Select keypad only or Computer and Video remote only Arrow buttons VolumeKeystone Effect remote only Black remote onlyContrast remote only Brightness remote only Using the On-Screen Menus Contrast Basic MenuBrightness Color Reset SetupAbout Picture menu Setup menu System menu Effect menu Language menu Service menu Userlogo menu Cleaning the Lens Maintenance & TroubleshootingCleaning the Dust Filters I n t e n a n c e Troubleshooting Replacing the Projection Lamp Replacing the Batteries in the Remote Control Using the Security Lock Problem The projector is not running TroubleshootingLEDs Problem Color or text not being projected Problem Only the start-up screen displaysProblem The screen resolution is not right Problem Image isn’t centered on the screen Problem Image is out of focus Problem Image is too wide or narrow for screenProblem Image and menus are reversed left to right Problem Projected image is distortedPage I n t e n a n c e Troubleshooting Appendix Specifications Standard Accessories Ship with the projector Part Number Accessories HW-RF-REMLSR Optional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation Chart FN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using SimulScan Using Video Mirroring with a PowerBook Computer Projected Image Size Numerics Index D e Page D e InFocus-Branded Products Limited Warranty Warranty Limitation and Exclusion