Operation
Starting up the projector
1.Plug the power cord into the projector and
into a wall socket. Turn on the wall socket switch (where fitted). Check that the Power indicator on the projector lights orange after power has been applied.
2. Remove the lens cover. If it is left on, it could become deformed due to the heat produced by the projection lamp.
3. Press II Power on the projector or remote control to start the projector. The Power indicator light flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before energizing the lamp.
4.If you are prompted for a password, press the arrow buttons to enter a six digit
password. See "Utilizing the password function" on page 24 for details.
5.Switch all of the connected equipment on.
6.The projector will start to search for input signals. The current input source being scanned displays on the screen. If the projector doesn't detect a valid signal, the 'No Signal' message will continue displaying until an input source signal is found.
You can also press SOURCE on the projector or remote control to select your desired input signal. See "Switching input signal" on page 27 for details.
22 Operation
