MECHANICAL INSTALLATION
NOTE: LCN recommends the use of a BodyMount P/N
1.The extrusion has
5 | 6 |
Pre Drilled
Mounting Holes
Approx. 9 ¾” Apart
2.Hold the Presence Sensor up to the
7 | 8 |
3.If Presence Sensor is mounted directly to door header, and cabling is to pass directly into header, drill a ¼” hole next to the Presence Sensor’s left side end cap to allow wire passage into header as shown below. The wire passage hole should be in a location that aligns with the cut out in the end cap as shown below.
9
ELECTRICAL INSTALLATION AND CABLING
Once the Presence Sensor is securely attached to header, cabling & wiring may be completed.
1.Install the
10
75.5255.02 XXXXXXXX
1 PWR |
| |
2 PWR |
| |
3 COM |
| |
4 NO |
| |
5 NC |
| |
6 | IN - |
|
7 | IN + | 10 PIN |
|
|
10 PIN
Position | Connection | Wire Color |
1 | 12 to 24 V AC / DC | Red |
| +/- 10% |
|
2 | 24 to 24 V AC / DC | Black |
| +/- 10% |
|
3 | Common | White |
4 | Normally Open | Green |
5 | Normally Closed |
|
6 | Data - | Brown |
7 | Data + | Blue |
Page 3 of 11