PROGRAMMING |
|
|
|
|
|
|
|
GUIDE – |
|
|
|
|
|
|
|
GENERAL |
|
|
|
|
|
|
|
FUNCTIONS |
|
|
|
|
|
|
|
REMOTE P/N |
|
|
|
|
|
|
|
|
|
|
| Number Keys |
|
|
|
|
|
| Number keys (0 through 9) are |
|
| ||
|
|
| used for assigning a value for a |
|
| ||
|
|
| given function |
|
| ||
|
|
|
|
|
|
|
|
Interface
1:
2:LO21 - Old Style (LO21, B, K, P, U)
Infrared Frequency
|
|
|
|
| Mode | Frequency |
|
1 | Normal | Low |
|
2 | Normal | High |
|
3 | Quiet | Low |
|
4 | Quiet | High |
|
See Note: Quiet Mode
Unlock |
Inquire |
Lock |
To UNLOCK the sensor:
Press the UNLOCK key once. Red LED flashes slowly. If flashing fast, see Note below.
Door Control
1:normal
(LED in normal mode)
2:door permanently open (red LED ON)
3:door permanently closed (red LED OFF)
To LOCK the sensor:
Press the LOCK key twice, OR press once then followed by a 4- digit lock code. If less than 4 digits, press lock again after the last digit. LED goes out when complete.
Output
Configuration
1 – Normally Open Relay
2 – Normally Closed Relay
To INQUIRE the sensor: Unlock the sensor, press the desired function key, followed by the INQUIRY key – the number of green flashes corresponds to the value.
Note: If sensor is locked, but code is unknown, power the sensor off and then back on. Press the UNLOCK key within 60 seconds.
Hold Tme
0 (0.5s) → 9 (9s)
Setup
launch a quick setup
restore factory defaults
launch a closed door setup
launch an open door setup
with one press of the unlock key, when set to 0000.
See Note: Automatic Setup
NOTE: AUTOMATIC SETUP: When performing an automatic setup (setup key pressed twice in a row), the sensor will begin to flash green during the door closed position, and will continue to do so until the door is activated to the open position. The LED will then go out and the door will close. The LED will flash green again at the closed position until a setup is complete. Upon the next activation, the sensor will launch another setup for the open door position, and will begin normal operation thereafter.
NOTE: QUIET MODE: The QUIET mode uses a different pulsing pattern to avoid interference with other infrared systems. The NORMAL mode transmits more energy and detects slightly in a more crisp fashion. The NORMAL mode is recommended for installations with only one door.
75.5255.02 XXXXXXXX |
|
Page 6 of 11 |
