Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
_Y, | :'< | ,, | U |
Install and store your washer where it will not freeze, Because some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:
•Unplug washer or disconnect power.
•Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.
•Slightly open door to provide ventilation.
To winterize washer:
1.Put 1 qt (1 L) of
2.Run washer on a SPIN cycle.
3.Unplug washer or disconnect power.
4.Shut off both water faucets.
5.Disconnect water inlet hoses from faucets and drain.
To use washer again:
1.Flush water pipes.
2.Reconnect water inlet hoses to faucets.
3.Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord,
Failure to follow these instructions can result in death,
fire, or electrical shock.
4.Plug in washer or reconnect power.
5.Run the washer through the Regular/Normal cycle with 1/4the normal recommended amount of HE detergent to clean out antifreeze.
To transport the washer:.
1.If washer will be moved during freezing weather, put in
1 qt (1 L) of
2.Unplug the power cord.
3.Remove drain hose from the standpipe or laundry tub. Attach the drain hose to the rear panel clips.
4.Shut off both water faucets.
5.Disconnect the water inlet hoses from faucets and rear of
washer. Drain the hoses and place them inside the washer drum.
IMPORTANT: Call service. Transport bolts should be installed prior to moving. The washer must be transported in the upright position to prevent suspension and structural damage.
Reinstalling the washer:
1.Follow the "Installation Instructions" to locate, level and connect the washer.
2.Run the washer through the Regular/Normal cycle with 1/4the
normal recommended amount of HE detergent to clean the washer and remove the antifreeze, if used.
TROUBLESHOOTING
First try the solutions suggested here to possibly avoid the cost of a service call...
Washer odor
Do you use HE or High Efficiency Detergent?
Use the following procedure without any clothing. Your washer interior should be cleaned at least once per month to reduce or prevent any accumulation of mold or mildew odors.
•Start by adding 1 cup (250 mL) of bleach into the detergent dispenser. Continue by adding 1 cup (250 mL) of bleach directly into the wash tub. This is the only time you should add anything other than clothing into the wash tub. Select and run the Regular/Heavy Soil cycle without clothing, using hot water. Repeat this process if necessary.
•Inspect the interior of the washer for lint and other debris that may accumulate on the basket and rubber bellows. Remove and dispose of any accumulation as necessary.
•Leave the washer door open between cycles to allow the washer interior to dry out.
16
