Inglis Home Appliances Washer manual Installationinstructions

•Do not ground to a gas pipe.

•Check with a qualified electrician if you are not sure the washer is properly grounded.

•Do not have a fuse in the neutral or ground circuit.

GROUNDING INSTRUCTIONS

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter,

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

A 120-volt, 60-Hz., AC-only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.

This washer is equipped with a power supply cord having a 3 prong grounding plug.

To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

For a grounded, cord-connected washer:

This washer must be grounded, in the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for electric current. This washer is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is

properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.

Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

For a permanently connected washer:

This washer must be connected to a grounded metal,

permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and

connected to the equipment-grounding terminal or lead on the appliance.

INSTALLATIONINSTRUCTIONS

2= For transport reasons, the drum is locked in position. Loosen the four transport bolts and remove them along with the plastic splined and rubber spacers.

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

•To prevent floor damage, set the washer onto cardboard before moving across floor.

•Using 2 or more people, move the washer to within approximately 3 ft (90 cm) of its final location.

To install the machine, follow the steps below:

1.Move the machine to its installation position.

\ %%

\

A. Plastic	splined	spacers	(4)	C. Flat washers	(4)
B. Rubber	spacers	(4)		D. Transport bolts (4)
NOTE: If the	plastic	spacers	cannot	be removed	from the
machine, call	for service.