Insignia IS-HTIB102731 owner manual Troubleshooting

Troubleshooting

If you experience any of the following difficulties	the system, eliminate the short-circuit problem
while using the system, use this troubleshooting	and turn on the power again.
guide to help you remedy the problem. Should	= The audio connecting cord is damaged. Re-
any problem persist, consult your nearest service	place it with a new one.
center.	= The system is in pause mode or in slow-motion
	play mode, or fast forward or fast reverse is

English

No power.

=Is the power cord firmly plugged into the power outlet?

=One of the safety mechanisms may be operat- ing. In this event, unplug the player from the power outlet briefly and then plug it in again.

No picture.

=Check that the system is connected securely.

=The video connecting cord is damaged. Re- place it with a new one.

=Make sure you connect the system to video input connector on the TV.

=Make sure you turn on the TV.

=Make sure you select the video input on the TV so that you can view the pictures from this sys- tem.

The picture noise appears.

=Clean the disc.

=If video from this system has to go through your VCR to get to your TV, the copy-protection applied to some DVD programs could affect pic- ture quality. If you still experience problems after checking your connections, please try con- necting your DVD system directly to your TV’s S-Video input, if your TV is equipped with this input.

The aspect ratio of the screen cannot be changed even though you set “TV DISPLAY” in the SETUP menu when you play a wide picture.

=The aspect rate is fixed on your DVD disc.

=If you connect the system with the S-Video cable, connect directly to the TV. Otherwise, you may not change the aspect ratio.

=Depending on the TV, you may not change the aspect ratio.

performed. Press ll to return to normal play mode.

=Check the speaker settings.

The left and right sounds are unbalanced or reversed.

=Check that the speakers and components are connected correctly and securely.

=Adjust front balance parameter using SELECT and VOLUME (- or +) buttons .

Severe hum or noise is heard.

=Check that the speakers and components are connected securely.

=Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light.

=Move your TV away from the audio compo- nents.

=The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.

=Clean the disc.

The sound loses stereo effect when you play a CD.

=Set the Audio mode to “STEREO” in the SETUP menu.

=Make sure you connect the system appropri- ately.

Radio stations cannot be tuned in.

=Check that the antennas are connected cor- rectly. Adjust the antennas and connect an ex- ternal antenna if necessary.

=The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

=No stations have been preset.

There is no sound or only a very low-level sound is heard.

=Check that the speakers and components are connected securely.

=Make sure that you have selected the correct source on the system.

=The protective device on the system has been activated because of a short circuit. Turn off

The remote does not function.

=Remove any obstacles between the remote control and the system.

=Use the remote control near the system.

=Point the remote control at the remote sensor on the front panel.

=Replace all the batteries in the remote con- trol with new one if they are weak.

=Check that the batteries are loaded correctly.

27