|
|
|
|
|
|
| Insignia | |
Setting up your DVD/TV |
|
| ||||||
| Note | |||||||
|
|
|
|
|
|
|
| Objects between the remote control and the |
| Installing the remote control batteries |
| sensor may weaken the remote control’s IR signal. | ||||||
| Range can be diminished by direct sunlight | |||||||
|
|
|
|
|
|
|
| shining on the DVD/TV’s IR sensor. |
To install the batteries:
1Remove the battery holder on the bottom of
the remote control. | Cautions |
| Do not expose the remote control to liquids, direct |
| sunlight, or shock. |
| The remote control may not work correctly if the |
| DVD/TV’s IR sensor is under direct sunlight or |
| strong lighting. In these cases, change the angle |
| of the lighting or the TV screen, or operate the |
| remote control closer to the IR sensor. |
2Insert the battery (provided) into the battery holder. Make sure that the (+) symbol on the battery matches the diagram on the holder.
3Reinsert the battery holder into the bottom of the remote control.
Note
•Do not connect the power cord until all other connections have been made.
•Each time you restart your DVD/TV, it remembers the last function used.
•Make all connections before installing your DVD/TV.
Connecting to a TV antenna
TV signal input
To connect an external TV antenna:
Using the remote control1 Connect the antenna cable to the ANT INPUT jack on the back of your DVD/TV.
To use the remote control:
•Point it directly at the TV, within a 60° angle of the IR sensor on the front of the TV, and within 23 feet (about 7 meters).
Notes
•The battery normally lasts for about six months, depending on how often and for what operations the remote control is used.
•If the remote control fails to work, even when it is operated near the player, replace the battery.
•If the remote control is not used for a long period of time, remove the battery from the compartment to prevent damage from battery leakage.
2Press the TV button on the remote control, or press the SOURCE button on your DVD/TV repeatedly, to set your DVD/TV’s signal input to TV.
Connecting to an ATSC (digital) signal source
ATSC signal input
To connect an ATSC (digital) signal source:
1Connect the cable from the ATSC source to the ATSC INPUT jack on the back of your DVD/TV.
2Press the DTV button on the remote control, or press the SOURCE button on your DVD/ TV repeatedly, to set the TV’s signal input to ATSC.
6 |