Insignia
Connecting to a radio antenna | Connecting the DVD output to a TV | ||
|
|
|
|
|
|
|
|
To connect a radio antenna:
1Connect the cable from the FM antenna (1), and the wires from the AM antenna (2), to their respective jacks on the back of TV.
2Press the FM/AM button on the remote control, or press the SOURCE button on the TV repeatedly, to set the radio’s signal input to FM or AM.
Warning
•If you connect your DVD/TV to an outdoor FM antenna, you should ground your DVD/TV in order to avoid the dangers of a lightning strike.
•To prevent a gas explosion, do not connect the ground wire to a gas pipe.
Notes
•In order to improve the signal, move the AM loop antenna away from your DVD/TV and other equipment.
•Extend the FM antenna fully.
•Keep the FM antenna as horizontal as possible after connecting it to the TV.
•If the FM reception is poor, use a 75 ohm coaxial cable (not supplied) to connect your DVD/TV to an outdoor FM antenna.
Connecting to an external AV signal source
To connect your DVD/TV to an external signal source:
1Turn off your DVD/TV and the signal source.
2Connect an RCA video cable to the VIDEO OUT jack of the signal source (for example, a VCR), then to the VIDEO Input jack on the back of your DVD/TV.
3Connect RCA audio cables to the signal source’s AUDIO OUT jacks, then to the Left and Right AUDIO Input jacks on the back of your DVD/TV.
4Turn on your DVD/TV and the signal source.
5Press the AV button on the remote control, or press the SOURCE button repeated on your DVD/TV to set the TV’s signal input to AV.
To connect the DVD output of your DVD/TV to an external TV:
1Turn off both TVs.
2Connect an RCA video cable to the VIDEO Output jack of your DVD/TV, then to the VIDEO Input jack on the back of the external TV.
3Connect RCA audio cables to the Left and Right AUDIO Output jacks of your DVD/TV, then to the Left and Right AUDIO Input jacks on the back of the external TV.
4Turn on your DVD/TV and the external TV.
5Set the signal source of the external TV to show the DVD output of your DVD/TV.
Connecting the audio output to an amplifier
Note
Refer to the operator’s manual of your amplifier before making any connections.
To connect the audio output of your DVD/TV to an external amplifier:
1Turn off your DVD/TV and the amplifier.
2Connect RCA audio cables to the Left and Right AUDIO Output jacks of your DVD/TV, then to the Left and Right AUDIO Input jacks
(1) on the back of the amplifier.
3Connect an RCA video cable to the VIDEO Output jack on your DVD/TV, then to the VIDEO Input jack (2) of an external TV.
4Turn on your DVD/TV and the amplifier.
5Set the signal source of the amplifier to the audio output of your DVD/TV.
7 |