Insignia NS-LCD22 Connecting the antenna, Before connecting devices, Locating the television

NS-LCD22.fm Page 6 Monday, February 19, 2007 1:39 PM

Insignia NS-LCD22 LCD TV

3 Replace the cover. Connecting the antenna

Caution

Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions below.

•Place batteries with their terminals corresponding to the (+) and (-) indications.

•Different types of batteries have different characteristics. Do not mix batteries of different types.

•Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries and/or cause old batteries to leak chemicals.

•Remove batteries as soon as they are non-operable. Chemicals that leak from batteries can cause a rash. If chemical leakage is found, wipe with a cloth.

•The batteries supplied with the remote may have a shorter life expectancy due to storage conditions.

•If the remote control is not used for an extended period of time, remove the batteries from the remote control.

Before connecting devices

•Carefully check the terminals for position and type before making any connections.

•The illustration of the external equipment may be different depending on your model.

•Loose connectors can result in image or color problems. Make sure that all connectors are securely inserted into their terminals.

•Refer to the user manual of the external device as well.

•When connecting an external device, turn the power off on the panel to avoid any issues.

Locating the television

Install the television in a room where direct light will not fall upon the screen. Total darkness or a reflection on the picture screen may cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.

Optimum reception of color requires a good signal and generally means that an outdoor antenna must be used. The exact type and position of the antenna depends upon your particular area.

TV Rear

Bronze

Wall antennawire socket

RF Coaxial Cable (75 ohm)

Antenna input

Note

•We recommend that the 75-ohm coaxial cable be used to eliminate interference and noise which may occur due to radio wave conditions.

•Do not bundle the antenna cable with the power cord.

•If you cannot install the antenna correctly, contact your dealer for assistance.

Connecting a VCR

AV cable

VCR

S-Video cable

TV Rear

Connect the Audio/Video cables between the Audio (L/R)/Video jacks on the television and VCR.

Note

Cables are often color-coded to connectors. Connect red to red, white to white, and yellow to yellow.

Note

•For better video, you can use the S-video terminal if your source supports it.

•The S-video terminal shares the same audio jacks with VIDEO and has priority over the VIDEO jack. To use a device connected to the video jack, disconnect any plug from the S-video terminal.

To play the VCR:

1Turn on your television, then press the INPUT button. The SOURCE INPUT menu opens.

2Press or to select Composite (or S-Videoif the S-VIDEO terminal is used), then press ENTER to confirm.

3Turn on your VCR, insert a videotape, then press the Play button.

6 www.insignia-products.com