Insignia NS-MDDVD10 Dual-Screen Portable DVD Player

Play to resume playback.

Troubleshooting

3 Press Pause to interrupt playback, and press

 

Note:

You also can press the GOTO function or use the numbered buttons to enter a photo number and quickly select any image.

Press the Angle button on the remote control to rotate the picture orientation by 90°.

Playable files

The ability of this unit to read MP3 discs is dependent on the following:

The bit rate must be from 64 to 256 kbps.

The total number of files on the disc should not exceed 254.

The maximum number of directories should not exceed 32.

The maximum level of directories should not exceed 4.

File names should use 7 or fewer characters, and must incorporate the “MP3” file extension. For example: *******. MP3 where each * is a letter or number.

Use only letters and/or numbers in file names. If you use special characters, the file and/or folder names may not be displayed correctly on the on-screen display.

When recording on CD-R discs, use 74-minute (650 MB) discs.

The CD-R or -RW discs should be finalized on the computer using single session format with recording speed less than 8x.

See your CD/MP3 creation software for more information.

Maintaining your DVD player

Cleaning the player

Wipe with a soft cloth. If the player is very dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean. Do not use compressed air to remove dust.

Caring for discs

Do not touch the surface of the unlabeled side of the disc.

Do not stick paper or tape on the surface of the disc.

Do not expose the disc to direct sunlight or excessive heat.

Do not use irregularly shaped discs (for example: heart shaped or octagonal). They may cause malfunctions.

Problem

Solution

 

 

No power

• Check that the AC power cord or the

 

 

DC power cord is connected.

 

• Make sure that the unit is turned on.

 

 

The remote

• Remove any obstacles between the

does not work

 

remote and the unit.

 

• Use the remote near the unit.

 

• Point the remote at the remote sensor

 

 

on the unit.

 

• Replace the battery in the remote with

 

 

a new one.

 

 

DVD has little

• Make sure that you have selected DVD

or no sound

 

mode.

 

• The system is in pause mode. Press

 

 

PLAY to return to normal play mode.

 

• DVD is in fast forward or fast reverse

 

 

mode. Press PLAY to return to normal

 

 

play mode.

 

• Make sure that AUDIO/VIDEO output

 

 

connections are correct.

 

• The DTS DVD disc cannot be decoded

 

 

for speaker output.

 

• This unit is too hot. Turn off the DVD

 

 

player and allow for it to cool for 30

 

 

minutes.

 

 

No picture

The region number of the disc doesn't match

 

the region number of this unit.

 

 

The picture is

The disc is scratched. Clean the disc.

not clear

 

 

 

 

Severe hum or

• The plugs and jacks are dirty. Wipe

noise is heard

 

them with a cloth slightly moistened

 

 

with alcohol.

 

Clean the disc.

 

 

The disc does

• There is no disc inside (No Disc

not play

 

appears on the screen). Insert the disc

 

 

correctly.

 

Clean the disc.

 

• A non-NTSC disc has been inserted.

 

 

The unit and disc region number are

 

 

incompatible.

 

• Condensation may have formed inside

 

 

the unit due to a sudden change in

 

 

temperature. Wait about an hour for

 

 

the condensation to clear and try

 

 

again.

 

 

 

Cleaning discs

A dirty disc causes sound skipping, and if the disc is very dirty, the disc may not work at all. Hold the disc by its inner and outer edges.

Fingerprints and dust should be carefully wiped from the surface of the DVD or CD with a soft cloth. Wipe in a straight motion from the center to the edge.

Never use thinner, benzine, record cleaner, or anti-static spray on a DVD or CD, because they can damage its plastic surface.

Note:

Before transporting the unit, remove any disc from the disc compartment.

www.insignia-products.com

17