Insignia NS-P501Q-10A manual Connecting satellite TV via a satellite TV box, Connecting a VCR

NS-P42Q-P501Q-P502Q-10A_09-0100_MAN_V1_English.book Page 11 Friday, March 20, 2009 3:11 PM

3Connect this cable to a two-way splitter.

Incoming cable

Splitter

4Connect the first coaxial cable between the OUTPUT jack on the splitter and the INPUT jack on the cable TV box.

Cable box

INPUT OUTPUT

Splitter OUT

5Connect the second coaxial cable between the ANT OUT jack on the cable box and the B–INjack on the RF (A/B) switch.

Cable box

INPUT OUTPUT

Splitter	RF (A/B)
	switch

6Connect the third coaxial cable to the other OUT jack on the splitter and to the A–INjack on the RF (A/B) switch.

Splitter		RF (A/B)
	Cable box	switch

7Connect the fourth coaxial cable between the OUT jack on the RF (A/B) switch and the ANT IN jack on the back of your TV.

TV back

ANT IN

Splitter

Cable box

8Set the A/B switch to the A position to view unscrambled channels, and set the switch to the B position to view scrambled channels. (When you set the A/B switch to the B position, you need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)

Connecting satellite TV via a satellite TV box

You can connect a satellite TV box using an HDMI, DVI, or component video connection. For more information, see:

•“Connecting an HDMI device” on page 12

•“Connecting a DVI device” on page 12

•“Connecting a component video device” on page 13

Connecting a VCR

To connect a VCR:

1Turn off your TV and all connected equipment.

2If the antenna or cable TV cable is connected to your TV, disconnect the cable from your TV.

3Connect the antenna or cable TV cable to the ANT IN jack on the VCR.

Back of TV

IN onVCR	Audio cable
To ANT
	Video cable

From ANT OUT on VCR to ANT IN on back of TV

4Connect a coaxial cable (not included) between the ANT IN jack on the back of your TV and the ANT OUT jack on the back of the VCR.

5Connect a video cable (not included) between the AV IN 1 (Y/VIDEO) jack on the back of your TV and the VIDEO OUT jack on the VCR.

6Connect an audio cable (not included) between the AV IN 1 R-AUDIO-Ljacks on the back of your TV and the AUDIO OUT jacks on the VCR.

Note

If the VCR is a “mono” (non-stereo) VCR, use a

Y connector to connect to the AV IN 1 R-AUDIO-Ljacks of the TV, or connect the audio cable to the AV IN 1 R jack.

7Turn on your TV, then turn on the VCR.

www.insigniaproducts.com 11