Insignia NS-P502Q-10A, NS-P501Q-10A, NS-P42Q10A Connecting an outdoor antenna, Connecting cable TV

NS-P42Q-P501Q-P502Q-10A_09-0100_MAN_V1_English.book Page 10 Friday, March 20, 2009 3:11 PM

Connecting an outdoor antenna

Connecting a coaxial antenna

To connect a coaxial antenna:

1Turn off your TV and all connected equipment.

2Connect the antenna cable to the ANT IN jack on the back of your TV.

ANT IN

Connecting a twin-lead antenna

To connect a twin-lead antenna:

1Turn off your TV and all connected equipment.

2Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not included). Use a screwdriver to tighten the screws.

3Connect the adapter to the ANT IN jack on the back of your TV.

ANT IN

Connecting separate VHF and UHF antennas

If you have separate VHF and UHF antennas, you need to connect the antennas to a combiner (not included).

To connect separate VHF and UHF antennas:

1Turn off your TV and all connected equipment.

2Connect both antenna leads to a combiner (not included).

UHF

VHF

3Connect the combiner to the ANT IN jack on the back of your TV.

ANT IN

UHF

VHF

Connecting cable TV

Without a cable box

To connect cable TV without a cable box:

1Turn off your TV and all connected equipment.

2Connect the cable TV cable to the ANT IN jack on the back of your TV.

ANT IN

Note

Because your TV is cable-ready, you do not need a cable box to view unscrambled cable channels.

With a cable TV box that unscrambles all channels

To connect a cable TV box that unscrambles all channels:

1Turn off your TV and all connected equipment.

2Connect a coaxial cable to the ANT OUT jack on the cable TV box. This jack may be labeled ANT OUT, VHF OUT, or OUT.

ANT IN ANT OUT

3Connect the other end of the cable to the ANT IN jack on the back of your TV.

ANT IN

4Connect another coaxial cable between the ANT OUT jack on the cable TV box and the cable TV wall jack.

Connecting a cable TV box that unscrambles some channels

If your cable box unscrambles only some channels (such as premium channels), you will need a two-way splitter, an RF (A/B) switch, and four additional coaxial cables.

To connect a cable TV box that unscrambles some channels:

1Turn off your TV and all connected equipment.

2Disconnect the cable that is connected to the cable in jack on the cable box. This jack may be labeled ANT IN, VHF IN, or IN.

Cable in jack

10 www.insigniaproducts.com