CARE AND USE
Electric Shock Hazard: To prevent electrical shock, disconnect power before servicing unit. Use only a properly grounded and polarized electric outlet.
ADJUSTING THE THERMOSTAT
Factory temperature | approx. 200° |
| |
To reset the thermostat to 200°, |
|
turn the indicator one notch to the |
|
right of vertical. After adjusting, |
|
depress or twist the dispenser handle |
|
for 20 seconds for water to |
|
the new setting. |
|
■To adjust water temperature, turn thermostat dial on the front of the tank clockwise to increase temperature or turn counter clockwise to decrease temperature. Repeat if necessary. All changes should be minimal.
Scalding Hazard: Do not allow water to boil. May result in severe burns.
PROPERTY DAMAGE
■Regularly inspect the unit for any signs of leakage. If there are signs of water damage, immediately remove the unit from service.
■To avoid water damage from leakage, replace all cut, loose or split tubing.
■A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage.
CLEANING THE FAUCET AND TANK
■Only use mild cleaners to clean the dispenser’s faucet and plastic components.
■Cleaners with acids, alkaline, and organic solvents will result in deterioration of the plastic components and void the warranty.
SEASONAL STORAGE/DRAINAGE
Anytime the instant hot water dispenser is not used for extended periods of time, unplug and drain unit. If it is below freezing you will need to unplug the unit and drain it.
■Disconnect power from unit.
■Push hot water dispenser faucet lever and allow water to flow until it is cool.
■Shut the dispenser off at the valve.
■Remove drain screw located on bottom center of dispenser tank and drain the water into empty pail.
■Empty the tank and then reinstall drain screw onto the bottom of tank, turning until snug. Do NOT over tighten.
■To place back in order, fill tank with water and
WARRANTY INFORMATION
1-year warranty on dispenser & tank
Covers all replacement parts and labor to correct defects in material or workmanship in the dispenser system for the full warranty period from the date of installation. The warranty includes parts and labor, provided the service is performed by an
The foregoing warranty does not apply to damage or inoperation resulting from accident, alteration, misuse, abuse, improper installation, installation not in accordance with these instructions or local electrical and/or plumbing codes. We do not assume any responsibility for consequential damage. Install using genuine
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental or consequential damages, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
8