InSinkErator C1300 Instant Hot Water Dispenser, What You Should Know Before You Begin, H778

Food Service Equipment

Instant Hot Water Dispenser

Installation, Care & Use Manual

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN

■For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this instant hot water dispenser.

■Make sure that all electrical wiring and connections conform to local codes.

■A standard 115-volt grounded electrical outlet is required for the dispenser’s electrical power.

■The wall outlet powering the dispenser must have power supplied to it continuously.

■To ensure proper operation, this unit is not intended to be flushed with chlorine. If you suspect elevated levels of chlorine in the water, it is recommended to use our water filtration system.

■Moving parts inside the tank causing a rattling noise is normal.

Equipment Required:

■ Drill	■ Phillips and flat blade screwdrivers
■ Compression fitting,	■ Pencil
T-fitting or saddle valve	■ Tape Measure
■ Adjustable wrench	■ Level

Equipment You May Need:

■ Anchors for drywall	■ Basin wrench
■ Hole saw	■ Hole punch

IN THIS PACKAGE

C1300	Rubber O-Ring	Hex Nut	Semi-circular	Hex Tool	3/4" Screws (2)
			Mounting Plate

H778 4" Extension Fiber Gasket Mounting Washer Mounting Screw 3/4" Screws (2)

2