5
FINAL WATER CONNECTION
A
Brass Nut
Ferrule
Property Damage: Join remaining tube
to cold water supply only.
■Install a compression fitting,
■At the end of the copper 1/4" tube, slide the fitting’s brass nut and ferrule over the tube.
■Insert the copper tube into the 1/4" compression fitting and tighten.
6
FILL TANK & THEN CONNECT POWER
A | ■ Turn on the cold water supply. |
| ■ Depress or twist the dispenser handle |
| and hold it until water flows from the spout. |
| ■ Run the water for at least 2 minutes to |
| flush lines (both the hot and cold handles |
| independently if applicable). |
Scalding Hazard: The faucet dispenses water up |
|
to 210ºF, which can instantly cause scalds or burns. |
|
Use care when operating this appliance. |
|
B
Property Damage: A standard grounded outlet within 30" of the dispenser is required under the sink. Do not use an extension cord set with the dispenser.
■Check all connections to ensure they are tight and that there are no leaks.
■Plug in instant hot water tank.
Water will be cold at first.
Allow
Gurgling or hissing is normal during the initial heating cycle.
Personal Injury: This tank is a
Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as rags, paper or aerosol cans near the tank. DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Property Damage: To avoid water damage, replace any loose or split tubing. Periodically inspect the unit for any signs of leakage and immediately remove from service any unit suspected of leaking.
For Technical Assistance
