2A | INSTALLING THE FAUCET - H778 |
H778 | |
| ■ Unpack dispenser components. |
| ■ On a firm, flat surface, carefully |
| straighten the copper tubing. |
Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.
B | H778 |
| |
| ■ Ensure that the fiber gasket is |
| properly seated against the base of |
| the dispenser head. |
Fiber |
|
Gasket |
|
Make sure to use fiber gasket | DO NOT remove mounting screw or |
to ensure proper seal. | fiber gasket from base of dispenser. |
C | H778 |
| |
| ■ Feed tubes down the hole in the sink |
| or countertop until the base is at rest |
| on the sink or countertop surface. |
| ■ Position faucet head at the desired |
| angle. |
An assistant may be needed to hold |
|
the dispenser head in place |
|
while securing the dispenser. |
|
D
Half moon shaped metal washer should cradle all descending tubes.
H778
■From below the sink, place semi- circular metal mounting washer over the mounting screw, ensuring the mounting washer extends beyond the sink hole.
■Slide washer over so that the screw is now inside the smaller hole. Tighten the screw until snug.
