InSinkErator H778 owner manual INSTALLING THE FAUCET - C1300, Make sure to use rubber O-ring

2A	INSTALLING THE FAUCET - C1300
	C1300
	■ Unpack dispenser components.
	■ On a firm, flat surface, carefully
	straighten the copper tubing.

Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.

B

Make sure to use rubber O-ring

to ensure proper seal.

C1300

■Ensure that the black O-ring is properly seated in the base of the dispenser head (the groove on the underside of the dispenser).

C

An assistant may be needed to hold

the dispenser head in place while securing the dispenser.

C1300

■Feed tubes down through the hole in the sink or countertop until the base is at rest on the sink or countertop surface.

D

Semi-circular mounting plate should

encircle all descending tubes and

extend beyond sink hole when tight.

C1300

■From under the sink, place the semi-circular mounting plate onto the threaded stud.

■Place hex nut onto the threaded stud. Ensure faucet head is at desired angle.

■Insert screwdriver into hole on side of hex tool (creating a “T”), and use tool to tighten nut and secure faucet.

4