InSinkErator H770 Final Water Connection, Fill Tank & Then Connect Power, HC-View / HC-Wave / HC3

5

FINAL WATER CONNECTION

A Brass Nut

Ferrule

Brass Inser

Plastic tube

Property Damage: Join remaining tube

to cold water supply only.

HC-View / HC-Wave / HC3

■Install a T-fitting (not included) onto the cold water supply line.

■Install dedicated water control valve with 3/8" compression fitting.

■At the end of the white 3/8" tube from the quick-connector, slide the supplied brass nut and ferrule over the tube and then push in the brass tube insert.

■Insert the white 3/8" tube into the 3/8" compression fitting and tighten.

A

Brass Nut

Ferrule

Copper tube

Property Damage: Join remaining tube

to cold water supply only.

H-View / H-Wave / GN3 / H990 / H770

■Install a T-fitting (not included) onto the cold water supply line.

■Install dedicated water control valve with 1/4" compression fitting (not included).

■At the end of the copper 1/4" tube, slide the brass nut and ferrule provided with the control valve over the tube.

■Insert the copper tube into the 1/4" compression fitting and tighten.

6

FILL TANK & THEN CONNECT POWER

A	■ Turn on the cold water supply.
	■ Depress the dispenser’s HOT handle
	and hold it until water flows from
	the spout (approximately 1 to 2 minutes).
	■ Run the water for at least 2 minutes to
	flush lines (both the hot and cold handles
Scalding Hazard: The faucet dispenses near-boiling	independently if applicable).
(212ºF) water which can instantly cause scalds or
burns. Use care when operating this appliance.

B

Property Damage: A standard grounded outlet within 30" of the dispenser is required under the sink. Do not use an extension cord set with the dispenser.

■Check all connections to ensure they are tight and that there are no leaks.

■Plug in instant hot water tank.

Water will be cold at first.

Allow 12-15 minutes for water to reach target temperature.

Gurgling or hissing is normal during the initial heating cycle.

11