Integra appendix from connecting block Mini plug cable, OUT DTM-5.3

Operating components not reached by the remote controller signals (IR IN/OUT)

The following equipment (sold separately) is essential for operation:

•Onkyo’s Multi-Room System kits (IR Remote Controller Extension System), or

•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few.

Controlling the DTM-5.3 in the main room from a remote zone (Zone 2)

The IR IN input allows you to control the DTM-5.3 from a remote zone (Zone 2) using the remote controller, even though the remote zone may be physically separated. The diagram below illustrates how to make the proper connections for the remote zone.

IR IN

IR Receiver

DTM-5.3

Connecting block

Remote controller

Main room Zone 2 room

: Signal flow

Make connection as shown below. Do not plug the equipment into the power source until the connection is completed.

from connecting block

Mini plug cable

IR

IN

OUT DTM-5.3

Controlling another component in the main room via the DTM-5.3 from a remote zone (Zone 2)

In this situation, you will need to use a commercially-available IR emitter. Connect the mini plug of the IR emitter to the IR OUT ter- minal on the DTM-5.3. Then place the IR emitter on the remote sensor of the component or facing it. When the IR emitter is con- nected, only the signal input to the IR IN terminal is output to the IR OUT terminal. The signal input from the remote sensor on the front of the DTM-5.3 will not be output to the IR OUT terminal.

IR OUT	IR IN
			IR Receiver
DTM-5.3
IR Emitter		Connecting
		block
other
component
			Remote controller
		Main room	Zone 2 room

: Signal flow

other component

Remote control sensor

Emitter

: Signal flow

Mini plug cable

Mini plug

IR

IN

OUT

IR Emitter

DTM-5.3

15