Using the remote controller
Master Volume
Standby/On |
|
|
|
|
|
|
| 1 ABC | 2 DEF |
| 3 GHI |
|
|
| |
|
|
|
|
|
|
|
|
| 4 JKL | 5 MNO | 6 PQR |
|
|
| |
|
|
|
|
|
|
|
|
| 7 STU | 8 VWX |
| 9 YZ- |
|
|
|
| Standby |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Direct Tuning | 0/10 | / | Scan |
|
|
|
Speakers |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
A | B |
|
|
|
|
|
|
|
| Clear |
|
|
|
|
|
| Zone 2 | Off | Display |
| Direct |
| Tuning |
| Memory | FM Mode | Character |
|
| ||
| Phones |
| DVD | Video | Tape 2 | Tape 1 | FM | AM | Phono |
|
| CD | Bass | Treble | Balance |
|
| Monitor |
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| L | R |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Standby/On |
|
|
|
|
|
|
| Memory |
|
| |||||
| On | |
Scan |
| |
Number | RCVR/Tape | |
buttons | ||
| ||
| Enter |
Setting the ID number
3Turn on the power to the
Programming the remote controller ID (This procedure is not required if you are using only one
If you are using multiple
The same ID number should be set on both the remote controller and the corresponding
To cancel the ID number, set the number to “0.” If the ID on the main unit is set to “0,” all remote controllers (with ID
Programming the ID number
1On the remote controller, while pressing and holding down the RCVR/Tape button, press the Enter button, then release both buttons.
The current ID number of the main unit appears on the display for five seconds.
Standby/On
Memory
Current ID
4While the current ID of the unit appears on the display, press the On button on the remote controller.
The remote controller will send its ID information to the unit, and the ID of the unit will be changed to match the remote con- troller’s ID.
Remote controller
Remote controller
2Press one of the number buttons
The number you pressed is set as the ID.
Remote controller
E.g.,
Press “3.”
For example, if you press “3” in Step 2: “UNIT ID 0” ➔ “UNIT ID 3”
The unit’s ID will change to “3.”
Hint:
You can use the number buttons on the main unit instead of press- ing the On button on the remote controller. In this case, press the same number as the remote controller’s ID (selected in Step 2).
Checking the remote controller’s ID:
Press the Scan button on the remote controller while the display indication shown in Step 4 appears. The remote controller’s ID appears on the display.
E.g., REMOTE ID 3
Note:
The unit will not respond to remote controller operations if the ID numbers do not match.
28
