Integra DTR-7.2 instruction manual Connections, Connecting your video components

Connections

: Signal flow

Audio connection cable

Left (white)	L
Right (red)	R
Digital audio input (optical)
Digital audio output (coaxial)
S Video input
Video input
Analog audio	R (red)
input
	L (white)

5.DVD recorder, other digital video recording device (VIDEO 2)

	R (red)
Analog audio	L (white)
output
Video output
S Video output	Y
	PB
Component video output	PR

Video connection cable	Component video connection cable
	PR	PR
	PB	PB
S video connection cable	Y	Y

							Digital audio output (coaxial)
							R (red)	Analog audio
								output
DIGITAL		PR	AUDIO	VIDEO	S VIDEO	COMPONENT	L (white)
OUTPUT		RENNA				VIDEO
	FRONT
					MONITOR	OUTPUT		Video output
OPT					OUT	Y
			R	L
	SUB
DIGITAL			AM	OUT	ZONE 2	PB
INPUT
COAX	SURR							S Video output
1				IN	DVD	PR
	SURR					INPUT 1
	BACK
2			FM	OUT		Y
			75
					VIDEO 1		4. DVD player (DVD)
3	FRONT			IN		PB
		IO
OPT	SUB	L
1			PH	OUT		PR
	SURR				VIDEO 2	INPUT 2
2			CD	IN		Y
	SURR		OUT
	BACK
3				IN	VIDEO 3	PB

RTAPE

DIGITAL			IN		VIDEO 4	PR
INPUT
GND	L	IN	L
		R		VIDEO	S VIDEO
	IO		AUDIO

Y

PB

PR

Component video output

Connecting your video components

Below is an example of how you can connect your video components to the DTR-7.2. Refer to the diagram above for the following connection examples.

The flow of the video signals is as follows:

•The signal that comes in from VIDEO IN is sent to VIDEO OUT and S VIDEO OUT.

•The signal that comes in from S VIDEO IN is sent to S VIDEO OUT and VIDEO OUT.

•The signal that comes in from COMPONENT VIDEO INPUT is only sent to COMPONENT VIDEO OUTPUT. When connecting a video player to the COMPONENT VIDEO INPUT terminals, be sure to connect your television to the COMPONENT VIDEO OUTPUT terminals.

Note:

If only the video connection for the MONITOR OUT is made, even if the input from each source component is through a component video connection, the picture will not appear. If only the S video connection for the MONITOR OUT is made, the picture will not appear.

4. Connecting a DVD player (DVD)

If the device is equipped with an S video output terminal, connect it to the DVD S VIDEO IN terminal with an S video cable. If it does not have an S video output terminal, connect its video output terminal to the DVD VIDEO IN terminal using an RCA-type video connection cable. You do not need to connect to both the DVD S VIDEO IN and DVD VIDEO IN terminals. If the device has component video outputs, connect them to one of the COMPONENT VIDEO INPUT jacks.

With the initial settings of the DTR-7.2, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jack.

If the video connection is made at COMPONENT VIDEO INPUT 2, this must be changed at the Setup menu: Input Setup → Video Setup

→Component Video (see page 36).

Using an RCA-type audio connection cable, connect the audio output terminal on the device to the audio DVD IN jacks on the DTR-7.2. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a digital output jack as well, be sure to also connect it to either a DIGITAL INPUT (COAX) or DIGITAL INPUT (OPT) jack on the DTR-7.2 depending on the type of connector on the DVD player.

17